[Assembled in California by mRo]
[Designed by AUAV]
We are now offering the mRo PixRacer R15 as an alternative/replacement.
Due to the depletion and retirement of the HMC5883, the mRo PixRacer R14 can no longer be made.
Many people will mistakenly believe that the PixRacer is just a standard "racer" controller that lacks many of the functionalities of a complete autopilot system. Well, don't be fooled! PixRacer has all the capabilities of the original PixHawk -including version 2- and even more! But is optimized in size and has just about the right amount of input/outputs that allows you to switch from a full enriched autopilot stack system -with autolanding and full navigation- to a high-performance racing platform. Yup, if you get tired of advanced precision waypoints, then flip the switch and race like a pro!
32-bit STM32F427 Cortex M4 core with FPU rev. 3
168 MHz/256 KB RAM/2 MB Flash
F-RAM Cypress MF25V02-G 256-Kbit nonvolatile memory (Flash memory that performs as fast as RAM)
SD Card slot with 8gb Micro SD card SanDisk. Adapter included
Invensense ICM-20608-G 3-axis accelerometer/gyroscope
Invensense MPU-9250 3-axis accelerometer/gyroscope/magnetometer
MEAS MS5611 barometer
Honeywell HMC5983 magnetometer temperature compensated
5x UART (serial ports), one high-power capable, 2x with HW flow control and GPS+I2C®
Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX9 and above.
Futaba S.BUS® & S.BUS2® compatible input
FRSky Telemetry port output
PPM sum input signal
OneShot PWM output (Configurable)
RSSI (PWM or voltage) input
External microUSB port
Dronecode Debug connector
WiFi Telemetry & firmware update via ESP8266
6x PWM outputs
Ultra low noise LDO voltage regulators
Weight and Dimensions:
Weight: 10.54g (.37 oz)
Width: 36mm (1.42”)
Length: 36mm (1.42”)