Home >

mRo PixRacer R15
mRo PixRacer R15


 
To buy this product, please proceed to our official reseller store
Our Price: $149.90

Quantity in Stock:(Out of Stock)


Availability:: Updated Link below
Product Code: AUAV-PXRCR-R15-MR
Qty:

Description What's Included Optional / Suggested Accessories
 

Please use the following link:

mRo PixRacer R15




For quotes on large orders and lead times, please send your inquiry to help@mrobotics.io or call us at 619-503-1003.


mRo with the special collaboration of AUAV.co is proud to announce the PixRacer MultiCopter kit! The cheapest, fastest and most genuine way to build your own "drone".
Many people will mistakenly believe that the PixRacer is just a standard "racer" controller that lacks many of the functionalities of a complete autopilot system. Well, don't be fooled! PixRacer has all the capabilities of the original PixHawk (including version 2) and even more! But is optimized in size and has just about the right amount of input/outputs that allows you to switch from a full enriched autopilot stack system (with autolanding and full navigation) to a high-performance racing platform. Yup, if you get tired of advanced precision waypoints, then flip the switch and race like a pro!


Specifications:

Microprocessor:
32-bit STM32F427 Cortex M4 core with FPU rev. 3
168 MHz/256 KB RAM/2 MB Flash

External Memory:
F-RAM Cypress MF25V02-G 256-Kbit nonvolatile memory (Flash memory that performs as fast as RAM)
SD Card slot with 8gb Micro SD card SanDisk. Adapter included

Sensors:
Invensense MPU-9250 3-axis accelerometer/gyroscope/magnetometer
Invensense ICM-20602 or ICM-20608 3-axis accelerometer/gyroscope
MEAS MS5611 barometer
ST LIS3MDL magnetometer

Interfaces:
5x UART (serial ports), 2x with HW flow control and GPS+I2C®
CAN
Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX9 and above.
Futaba S.BUS® & S.BUS2® compatible input
FRSky Telemetry port output
Graupner SUMD
Yuneec ST24
PPM sum input signal
OneShot PWM output (Configurable)
RSSI (PWM or voltage) input
I2C
SPI
External microUSB port
JTAG
Dronecode Debug connector
WiFi Telemetry & firmware update via ESP8266 (Included!)
6x PWM outputs
JST-GH connectors using Dronecode connector standard

Power System:
Ultra low noise LDO voltage regulators

Weight and Dimensions:
Weight: 10.54g (.37 oz)
Width: 36mm (1.42”)
Length: 36mm (1.42”)

USER GUIDE

Click here for quick Start and User Guide

[Made in USA]


Share your knowledge of this product. Be the first to write a review »