[Retired] The mRo X2.1-777 is the reduced version of Pixhawk1 with better sensors and more flexibility with the advanced STM32F777 microcontroller.

PixRacer Telemetry to Picoblade.

Protect your PixRacer and look great doing it.

4-Pin JST-GH to 4-Pin Molex PicoBlade 51021. Allows you to adapt PixRacer to your FrSky-D module.

This 2 position DF13 is commonly used to wire your buzzer on Pixhawk1.

This is a simple 2P JST-GH wire cable.

This is a simple 3P JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST-GH connector on one end, bare cable on the opposite end.

This is a simple 4P JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST-GH connector on one end, bare cable on the opposite end.

This is a simple 5P JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 5-pin JST-GH connector on one end, bare cable on the opposite end.

This is a simple six JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST-GH connector on one end, bare cable on the opposite end.

This 3P DF13 is commonly used to wire your safety button + LED on Pixhawk1.

Common MRC0230 applications:
- Wire your own button and LED onto Pixhawk

Used for X2.1, Power module.

APM Telemetry to Radio Telemetry.

4-Pin JST-GH to 4 Separated 2.54mm female headers.

Allows you to connect your PixRacer to FrSky-S.Port.

4-Pins JST-GH to JR Servo Female. This cable will allow you to connect your RSSI signal to PixRacer.

Classic 4-position DF13 to DF13. Commonly used on Pixhawk1 to connect I²C and CAN devices.

Pixhawk mini Telemetry to mRo Telemetry.

mRo 6-Pin JST-GH to 6-Pin JST-SH.

[3-Pin 2.54mm header] to [3-Pin JST-ZHR].

Allows you to connect old DF13 I²C/CAN devices to new JST-GH I²C/CAN devices.

Pixhawk1 GPS port to new generation GPS with NO I²C support.

Dronecode.org standard. Used for Telemetry, GPS, Power Module.

PixRacer to 3DR GPS (DF13) and Pixhawk GPS+I²C port to new generation GPSs.

For OSD, Hacking, Prototyping on 6-pin JST-GH Connectors.