The mRo JST-GH I²C Bus Splitter is a fantastic way to branch out your I²C signal. This device allows you to connect more I²C devices by sharing the same bus.

The mRo JST-GH I²C Bus Splitter is a fantastic way to branch out your I²C signal. This device allows you to connect more I²C devices by sharing the same bus.

PixRacer to 3DR GPS (DF13) and Pixhawk GPS+I²C port to new generation GPSs.

Pixhawk1 GPS port to new generation GPS with NO I²C support.

For OSD, Hacking, Prototyping on 6-pin JST-GH Connectors.

Connect PixRacer or any device following Dronecode.org standard into I²C/CAN devices.

Dronecode.org standard. Used for Telemetry, GPS, Power Module.

3DR Solo GPS to Pixhawk1 GPS port.

3DR Solo GPS to PixRacer GPS port or any device following Dronecode.org GPS Connector standard.

3DR Solo to Stock 3DR Solo GPS or improved mRo GPS for Solo, can be used as a stock replacement.

Classic 6-position DF13 to DF13. Commonly used on Pixhawk1 to connect Telemetry and Power Module.

This cable is designed for CAN applications.

4-Pin JST-GH to 4 Separated 2.54mm female headers.

6-Pin JST-GH to 6-Pin JST-SH.

Piezo buffer for Pixhawk1. Emits annoying sounds to alert you.

4-Pin JST-GH to 4-Pin Molex PicoBlade 51021. Allows you to adapt PixRacer to your FrSky-D module.

Allows you to connect your PixRacer to FrSky-S.Port.

4-Pins JST-GH to JR Servo Female. This cable will allow you to connect your RSSI signal to PixRacer.

This 2 position DF13 is commonly used to wire your buzzer on Pixhawk1.

This is a simple 2P JST-GH wire cable.

This is a simple 3P JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST-GH connector on one end, bare cable on the opposite end.

This is a simple 4P JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST-GH connector on one end, bare cable on the opposite end.

This is a simple 5P JST-GH wire cable. Great for jumping from board to board or just about anything else. There is a 5-pin JST-GH connector on one end, bare cable on the opposite end.