For quotes on large orders and lead times, please send your inquiry to email@example.com or call us at 619-503-1003.
mRo with the special collaboration of AUAV.co is proud to announce the PixRacer MultiCopter kit! The cheapest, fastest and most genuine way to build your own "drone".
The kit includes a PixRacer Flight Controller, GPS w/ GLONASS+Compass, 10S Power Module (ACSP5), 915MHz/433MHz Telemetry Radio Pair and all Cables needed.
Many people will mistakenly believe that the PixRacer is just a standard "racer" controller that lacks many of the functionalities of a complete autopilot system. Well, don't be fooled! PixRacer has all the capabilities of the original PixHawk (including version 2) and even more! But is optimized in size and has just about the right amount of input/outputs that allows you to switch from a full enriched autopilot stack system (with autolanding and full navigation) to a high-performance racing platform. Yup, if you get tired of advanced precision waypoints, then flip the switch and race like a pro!
32-bit STM32F427 Cortex M4 core with FPU rev. 3
168 MHz/256 KB RAM/2 MB Flash
F-RAM Cypress MF25V02-G 256-Kbit nonvolatile memory (Flash memory that performs as fast as RAM)
SD Card slot with 8gb Micro SD card SanDisk. Adapter included
Invensense MPU-9250 3-axis accelerometer/gyroscope/magnetometer
Invensense ICM-20602 or ICM-20608 3-axis accelerometer/gyroscope
MEAS MS5611 barometer
ST LIS3MDL magnetometer
5x UART (serial ports), 2x with HW flow control and GPS+I2C®
Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX9 and above.
Futaba S.BUS® & S.BUS2® compatible input
FRSky Telemetry port output
PPM sum input signal
OneShot PWM output (Configurable)
RSSI (PWM or voltage) input
External microUSB port
Dronecode Debug connector
WiFi Telemetry & firmware update via ESP8266
6x PWM outputs
Ultra low noise LDO voltage regulators
Weight and Dimensions:
Weight: 10.54g (.37 oz)
Width: 36mm (1.42”)
Length: 36mm (1.42”)
Click here for quick Start and User Guide
[Made in USA]