Home > All >

mRo CAN Power Module
mRo CAN Power Module


 
Alternative Views:


To buy this product, please proceed to our official reseller store
Our Price: $99.90
Harmonized Tariff Code: 9032.89
ECCN: EAR99


Availability:: Available at 3DR Store
Product Code: M10104

Power Module Options:

XT90 Loose - DIY soldering required
XT90 Pre-Soldered
XT60 Loose - Soldering required
XT60 Pre-Soldered

Go to 3DR Store  
Description What's Included
 
The mRo was built from scratch to deliver our latest high-quality power module. The sensor is based on the ACS37800 power monitoring IC, which provides 0.85 mΩ primary conductor resistance for low power loss and high inrush current capabilities. It has excellent accuracy over the entire range
The integrated capacitors reduce voltage noise, however we still recommend to install the included electrolytic capacitor to compensate for long battery wire lengths and motor noise.

NOTE: mRo Control Zero w/ Aluminum enclosure and 'Stick' carrier board are not included!
Electrical:
  • 50.4V 12S LiPo
  • 60 Amps Continuous - 90 Amps Max Current Sensing
  • 5.3V, 3A power supply
Default Settings:
  • Set BATT_MONITORx to 8 (CAN)
Mechanical:
  • Board Weight: 5.90g (0.208 oz)
  • Board Dimensions:
    • 26mm x 26mm (1.02"x1.02")
Accesories included:
  • Molex ClikMate 2mm 6-pin to 2x JST-GH cable (6-pin PWR and 4-pin CAN)
  • JST-GH 4 to JST-GH 4 cable

Important! The module comes with pre-calibrated values, however end users are encouraged to verify and tune constants provided in the module's paramaters.
BATT_V_FINE_M and BATT_C_FINE_M are multipliers (1.0 default) to fine tune your power readings for your airframe. Keep a safe margin of battery capacity until calibrated and confirmed.

[Designed and assembled in USA]

Share your knowledge of this product. Be the first to write a review »