[Assembled in California by mRo]
[Designed by AUAV]
We are now offering the mRo PixRacer R15 as an alternative/replacement.
Due to the depletion and retirement of the HMC5883, the mRo PixRacer R14 can no longer be made.
Many people will mistakenly believe that the PixRacer is just a standard "racer" controller that lacks many of the functionalities of a complete autopilot system. Well, don't be fooled! PixRacer has all the capabilities of the original PixHawk -including version 2- and even more! But is optimized in size and has just about the right amount of input/outputs that allows you to switch from a full enriched autopilot stack system -with autolanding and full navigation- to a high-performance racing platform. Yup, if you get tired of advanced precision waypoints, then flip the switch and race like a pro!
Specifications:
Microprocessor:
32-bit STM32F427 Cortex M4 core with FPU rev. 3
168 MHz/256 KB RAM/2 MB Flash
External Memory:
F-RAM Cypress MF25V02-G 256-Kbit nonvolatile memory (Flash memory that performs as fast as RAM)
SD Card slot with 8gb Micro SD card SanDisk. Adapter included
Sensors:
Invensense ICM-20608-G 3-axis accelerometer/gyroscope
Invensense MPU-9250 3-axis accelerometer/gyroscope/magnetometer
MEAS MS5611 barometer
Honeywell HMC5983 magnetometer temperature compensated
Interfaces:
5x UART (serial ports), one high-power capable, 2x with HW flow control and GPS+I2C®
CAN
Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX9 and above.
Futaba S.BUS® & S.BUS2® compatible input
FRSky Telemetry port output
Graupner SUMD
Yuneec ST24
PPM sum input signal
OneShot PWM output (Configurable)
RSSI (PWM or voltage) input
I2C
SPI
External microUSB port
JTAG
Dronecode Debug connector
WiFi Telemetry & firmware update via
ESP8266 (Included!)
6x PWM outputs
Power System:
Ultra low noise LDO voltage regulators
Weight and Dimensions:
Weight: 10.54g (.37 oz)
Width: 36mm (1.42”)
Length: 36mm (1.42”)