The Control series of flight controller from mRo is our commitment to continuous improvement. Our goal with this series was to take every lesson learned from our 10+ years of flight controller design and make the best pro-consumer / commercial flight controller on the market.

Small-sized 20mm (.79”) x 32mm (1.26”) Multi-purpose Autopilot. H7 CPU, 8x PWMs w/ Dshot, 6x Serials, I2C, CAN. ArduPilot & PX4 compatible.

High-performance GPS capable of simultaneously using all constellations, including the more precise L2 band, making it one of the most precise GPS available today.

The mRo JST-GH I²C Bus Splitter is a fantastic way to branch out your I²C signal. This device allows you to connect more I²C devices by sharing the same bus.

The mRo GPS NEO-M8N is a professional grade, robust GPS system capable of sensing USA (GPS), Russian (GLONASS) and European (Galileo) constellations at the same time.

Extremely powerful GPS system capable of using multiple constellations. 3DR Solo Compatible.

Extremely powerful GPS + Compass system capable of using multiple constellations at the same time in order to provide you with a super+combo+awesome accurate position and heading.

The mRo JST-GH I²C Bus Splitter is a fantastic way to branch out your I²C signal. This device allows you to connect more I²C devices by sharing the same bus.

Highly compressible, ultra soft silicone foam, better known as the damping foam for Pixhawk.

PixRacer to 3DR GPS (DF13) and Pixhawk GPS+I²C port to new generation GPSs.

Pixhawk1 GPS port to new generation GPS with NO I²C support.

For OSD, Hacking, Prototyping on 6-pin JST-GH Connectors.

Connect PixRacer or any device following Dronecode.org standard into I²C/CAN devices.

Dronecode.org standard. Used for Telemetry, GPS, Power Module.

3DR Solo GPS to Pixhawk1 GPS port.

3DR Solo GPS to PixRacer GPS port or any device following Dronecode.org GPS Connector standard.

3DR Solo to Stock 3DR Solo GPS or improved mRo GPS for Solo, can be used as a stock replacement.

Classic 6-position DF13 to DF13. Commonly used on Pixhawk1 to connect Telemetry and Power Module.

This cable is designed for CAN applications.

4-Pin JST-GH to 4 Separated 2.54mm female headers.

6-Pin JST-GH to 6-Pin JST-SH.

Piezo buffer for Pixhawk1. Emits annoying sounds to alert you.

4-Pin JST-GH to 4-Pin Molex PicoBlade 51021. Allows you to adapt PixRacer to your FrSky-D module.